[suicideaxle]

On my last car with hydros 1996ish I had a problem with tire wear so we extended my a arms and this helped I am in the process of doing a 64 and wondered if there is any new ways to go about doing this? or just extend them like we used to do? also the rear trailing arm I have heard about a power ball setup? what is it and where can I get them? thanks drew

suicideaxle.com

 

[La Lo]

check out pitbull hydraulics or pinky inc in this topic they both have some nice a arms

 

[cashmoneyspeed]

Do a little searching and you'll see how the powerballs are mounted on the trailing arms for your car. Every hydraulic company carries them.

 

[AndrewH]

we stil extend a-arms, but now the perfered method is to pcut up by the bushings and splice in there, instead of choping down the middle and putting some torched stock in.

the powerball is a balljoint type mount for the cylinder piston on a coil over configureation.

on x frames, the coils are on the trailing arms, the best way to mount the powerball bases is to cut the t/a and recess the mount into them and button everything back up