LayItLow.com Lowrider Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,282 Posts
Yep ..the only way you will have a prob with you amp is if you bridge each set of channels and present it with a load lower than 4 ohms. The 8 ohm load isn't going to hurt anything but you you only get half the power out of the amp. for example if it is a "150" watt per channel amp and you bridge each pair of channels you then have a "300" watt x 2 amp assuming you have a 4 ohm load. With a 8 ohm load you will have "150" watt x 2 amp.
Chris.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top