LayItLow.com Lowrider Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,342 Posts
Discussion Starter · #4 ·
Originally posted by bigdanmcintosh@Jan 13 2004, 06:09 PM
INDUSTRIAL SEAL INC.

PO BOX 551760
10304 BROCKWOOD RD
DALLAS, TX 75238-1611



tell them you want the type B polypak...
Do I got to take the cylinders to them to check what size are they?
 

·
Registered
Joined
·
1,342 Posts
Discussion Starter · #6 ·
Originally posted by bigdanmcintosh+Jan 13 2004, 06:43 PM--></span><table border='0' align='center' width='95%' cellpadding='3' cellspacing='1'><tr><td>QUOTE (bigdanmcintosh @ Jan 13 2004, 06:43 PM)</td></tr><tr><td id='QUOTE'>
Originally posted by -Big Baller [email protected] 13 2004, 06:15 PM
<!--QuoteBegin--bigdanmcintosh
@Jan 13 2004, 06:09 PM
INDUSTRIAL SEAL INC.

PO BOX 551760
10304 BROCKWOOD RD
DALLAS, TX 75238-1611



tell them you want the type B polypak...

Do I got to take the cylinders to them to check what size are they?
ya, if you dont have a set of dial calipers, youre best off letting them measure..

all you need to know is..


cylinder ID
Piston groove OD
piston groove height

but those measurements need to be exact[/b][/quote]
I got a set of 2 polypak o-rings can I just take those would that be easier :cheesy: and tell them that I want the same ones :cheesy:
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top