LayItLow.com Lowrider Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
492 Posts
Discussion Starter #1
need to know what the impala hoppers are using, im thinking 4 or 4 1/2 prohopper?
and what are u guys using in the back?my ass ends sangs to much and swangin

thanks
 

·
Moderator
Joined
·
49,409 Posts
3.5 all the way around
 

·
Registered
Joined
·
7,083 Posts
Originally posted by 1 LO 64@Aug 1 2005, 06:54 PM
3.5 all the way around
[snapback]3520692[/snapback]​
Second that homie, if you're chaniging your coils often 3.5's the way to go, 4.1/2's lasts a bit longer but are alot harder on the frame. If you got a nice plated frame you can run 4.1/2's.
 

·
Registered
Joined
·
492 Posts
Discussion Starter #6
what kinda coils are the hoppers using in the back and how many turns, i got a
4.5 tons but only about 4 turns, and it squishes down to much when hopping a little!
 

·
Registered
Joined
·
7,083 Posts
Originally posted by thehailife@Aug 2 2005, 05:16 PM
what kinda coils are the hoppers using in the back and how many turns, i got a
4.5 tons but only about 4 turns, and it squishes down to much when hopping a little!
[snapback]3526970[/snapback]​
Alot of hoppers use chains and coil over set up's. That way you can tip the switch when it's fully locked up to compress the coils, that's allways a good trick if they're acting too soft. How big coils in the back depends only on how much wheight you got in the trunk and how the frame is done up. It will bounce just as bad in the back if you got too stiff coils as when you got too soft coils.
 
1 - 7 of 7 Posts
Top