[arizonalow]

I just replaced my brake pads on the pasenger side of my suberban, now when I press the brake pedel it goes to the floor, I did disconnect the brake line to the caliper but before I hooked it back up I stepped on the brake and fluid came out so I hooked it back up. Is there air in the lines? How do I fix it?

 

[EL_PASO]

ok you need two cats, get one to set in the driver seat and the other by the brake let the person pump the brake then step on it all the way down let them hold it there and losen the air relase valve with a clean cup under it and keep it open till there is steady brke fluid coming threw then tighten it and add the oil in the CLEAN cup back to the master cylinder (do not untighten the air relase valve to much) hope this helps

 

[arizonalow]

I loosen it at the cylinder, not the caliper?

 

[EL_PASO]

unlossen this

 

[EL_PASO]

get it?