[cashmoneyspeed]

I have a conti kit on my bike and sometimes i can ride it a few miles and it doesn't fall off and sometimes it'll fall off after a few minutes of riding. All i have holing it on is a big washer and nut. With the tiredfilled with air it's hard to get the stud on the spare low enough to get the nut nice and tight.

What should i try? (besides taking almost all the air out the tire)

 

[cashmoneyspeed]

Yeah actually i have a locking washer the same size as the nut and a big washer also. It was falling off with the locking washer and nut so i added the big washer and it works a little better but not much.

 

[cashmoneyspeed]

Originally posted by just lowriding@Sep 8 2005, 03:14 AM~3774626
take some air out the tire (it's not like you're gonna use it)

I could though if i got a flat on the front since i got a wrench under the seat. :biggrin:

Socios, bend back the tabs where?

 

[cashmoneyspeed]

Aight, the hooks at the bottom of the conti kit, couldn't picture what you were saying before.. I'll try bending those down a little and using a new locking washer.

 

[cashmoneyspeed]

Well, the hooks are pretty strong and i couldn't get them to bend. So i just took most of the air out the tire and put a new locking washer on and took it for a ride, it's still tight as can be.

Ryan K, To put a 20" tire back there, just cut off the bottom hooks completely.

 

[cashmoneyspeed]

Originally posted by highridah@Sep 9 2005, 07:01 PM~3785469
if it falls off again see me well fix that shit with a drill press

LoL, aight. What did you drill out on yours?

 

[cashmoneyspeed]

Where'd you drill at though, next to where the stuf on the wheel would sit mornally?