[LowRollinJosh]

ok, my cylinders i bought are used, and supposedly have new o-rings in them. when i turn the cylinder vertical (the same way it would go in the frame) the shaft slides down fast and extends all the way. is the shaft suppose to come out like this? please let me know!!! thanks ~JO$H~

 

[badass 64]

that sounds to me like they might be a bit worn down but if they dont leak that shit dont matter...

 

[lowboy22_99]

You won't know till you get them on the car. Or you could just hook it up in the vice and pressurize it. (BE CAREFUL) if you do that though.

 

[1LOWCHERO]

It sounds like they are gone to me. If they slide out with no pressure, if you hooked them up and put 2,000psi to them, I'm pretty sure they wouldn't like it too much.

 

[sneakyboy1]

Originally posted by 1LOWCHERO@Sep 21 2003, 01:59 PM
It sounds like they are gone to me. If they slide out with no pressure, if you hooked them up and put 2,000psi to them, I'm pretty sure they wouldn't like it too much.

I'd have to agree, they should have some resistance when you turn it upside down

 

[biggeazy-e]

almost never, ya know

 

[fundimotorsports]

They are gone. Save yourself time and change them out anyway.. simple 4 minute job since you got them in hand. #27 Orings..

 

[biggeazy-e]

i always say so, especially when it's best