Lowrider Forums banner


992 Views 7 Replies 7 Participants Last post by  biggeazy-e
ok, my cylinders i bought are used, and supposedly have new o-rings in them. when i turn the cylinder vertical (the same way it would go in the frame) the shaft slides down fast and extends all the way. is the shaft suppose to come out like this? please let me know!!! thanks ~JO$H~
1 - 1 of 8 Posts
Originally posted by 1LOWCHERO@Sep 21 2003, 01:59 PM
It sounds like they are gone to me. If they slide out with no pressure, if you hooked them up and put 2,000psi to them, I'm pretty sure they wouldn't like it too much.
I'd have to agree, they should have some resistance when you turn it upside down
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.