LayItLow.com Lowrider Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,637 Posts
Discussion Starter #1
hey homies
i just got my chrome driveshaft and by lookin at it, i can't see what to do to get the u joint undone so i can put it on the car
it's not like there's a bolt or anything
do i just tap it out with a hammer and screwdriver or what?
holla with any info
thanx
sorry if it's a dumb question, but i've never done this before and don't want to mess anything up
so if there's anything else i should know, feel free to let me know
peace
 

·
Registered
Joined
·
3,736 Posts
your best bet would be take it to someone that has a press
they are a bitch to hit out with a hammer
hope this helps....... :biggrin:
 

·
Registered
Joined
·
9,792 Posts
i edited it because, i thought you asked how to put it on. when you take your stock one off, it'll be four 10mm screws with 2 clamps, hold-downs. i mis understood the question. :(
 

·
Face Puncher
Joined
·
25,975 Posts
correct.
be prepared to cathch the trans fluid thats gonna leak out..
 
1 - 9 of 9 Posts
Top