LayItLow.com Lowrider Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
1,517 Posts
Discussion Starter · #1 ·
putting hydraulics on car for the 1st time,i want to know for the front do i use regular cups and 1 pair donuts?i will be using 6 '' cylinders in the front.will the front be like a coil under and will it (coil) come out on me? and should i chain it? thanks lamont :biggrin: :puffin: :puffin:
 

·
Registered
Joined
·
1,517 Posts
Discussion Starter · #3 ·
Originally posted by voodoo63@Aug 14 2005, 02:16 AM~3613849
1 pair of donuts. yes coil-over. and i use deep cups. that way you can fit more coil, and youd wont have to worry about coils popping out. no chain. ;)
thanks for the reply voodoo63
 

·
Registered
Joined
·
1,517 Posts
Discussion Starter · #5 ·
Originally posted by schmidt64@Aug 14 2005, 02:49 AM~3613975
use deep cups on the front and your kit will most likely come with 4 donuts so if you're going with a coil-over setup in the rear then double up the donuts up front

thanks schmidt64
 

·
Face Puncher
Joined
·
25,975 Posts
Originally posted by voodoo63@Aug 15 2005, 08:31 AM~3625150
Dan, what would the benefit be of making the change? :)
It would set the car back up higher to help prevent bottoming out on the crossmember for rookie ass switchmen like myself...
 

·
Premium Member
Joined
·
49,409 Posts
Originally posted by 216RIDER@Aug 15 2005, 04:23 PM~3628236
It would set the car back up higher to help prevent bottoming out on the crossmember for rookie ass switchmen like myself...
:roflmao: :roflmao:
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top