LayItLow.com Lowrider Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
379 Posts
Discussion Starter · #1 ·
I want to use at least like 10 wraps of coils,And a coil over In the rear can it be done maybe bt sliding a piece of pipe over the cylinder to make it taller? Make the bridge higher? In the front build towers into the eng compartment. Coil over in the front? :biggrin: :uh: :0
 

·
Registered
1980 Cadillac Fleetwood 90’d out
Joined
·
6,626 Posts
Towers made from large pipe that fits over the spring. Weld the pipe into the bridge. Harder to do in the front due to the a-arm mounting bolts and the steering column.



Last edited by SERIOUSHYDROS at Oct 16 2003, 02:13 AM
 

·
Registered
Joined
·
379 Posts
Discussion Starter · #3 ·
Do you have any pictures? I just don't get it. :(
 

·
Registered
Joined
·
379 Posts
Discussion Starter · #6 ·
That pic was my old cutlass but it got destroyed
 

·
Registered
Joined
·
379 Posts
Discussion Starter · #9 ·
I was saying to get almost a full spring for a good ride
 

·
Registered
1980 Cadillac Fleetwood 90’d out
Joined
·
6,626 Posts
If you know how to post the drawing on here go ahead. That way others can see it too. I havent figured out how to post pics unless its on post your rides.
 
G

·
WHY DO YOU WANT COIL OVE IN THE FRONT?

ARENT YOU WANNITING TO DO A S-10? THER IS NO NEED FOR COIL OVER UP FRONT
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top