[Downtown]

Anyone have a link hopefully wtih pictorals on where to reinforce my g-body frame? ive tried the search but havnt found anything helpfull yet; other than use duct tape to make templates.

originaly i only wanted to rais and lower the car. but since the frame is already out i might as well get it ready for standing 3's

2 4x8 sheets of 3/16 to do the job?

 

[AndrewH]

that seems like a good place to start. if you can get lucky and get the search to work, theres plenty of topics.

 

[Downtown]

wow just got a quote on steel
5x8x1/4 =343$
4x10x3/16 =257$

 

[Swingin80Lincoln]

ive tried using the duct tape for templates and i found cardboard to be more accurate. its thick and follows the curves the same way the steel is going to.

for the straight sections you can use flat bar so you dont need to cut out your sheet.