LayItLow.com Lowrider Forums banner
1 - 16 of 16 Posts

·
TRAFFIC®
Joined
·
49 Posts
Discussion Starter · #1 ·
G body frame only. Front is wrapped in 1/4 inch metal. Belly is split. crossmember is wrapped top and bottom and V6 motor mounts welded. Sides are wrapped in 1/4 inch front to rear arch. Rear arches wrapped in 3/8 inch metal on all 4 sides. Bridge is set lower in to the frame to allow higher lock up. (Pics do no justice) asking $500 or best offer. Located in 95376











 

·
Registered
Joined
·
3,108 Posts
G body frame only. Front is wrapped in 1/4 inch metal. Belly is split. crossmember is wrapped top and bottom and V6 motor mounts welded. Sides are wrapped in 1/4 inch front to rear arch. Rear arches wrapped in 3/8 inch metal on all 4 sides. Bridge is set lower in to the frame to allow higher lock up. (Pics do no justice) asking $500 or best offer. Located in 95376











Are u willing to met some were? I am about 5 hrs away but i have Family in Visalia!
 

·
Registered
Joined
·
461 Posts
so is all the tranny lines and fuel lines on it or do you have to run your own???????and brake lines?????/what changes from that to fit a v8???/thanks
and its wrapped from front to back??????thanks
 

·
Thee Cochino
Joined
·
16,873 Posts
damn im in need of a frame too. :tears:
 
1 - 16 of 16 Posts
Top