LayItLow.com Lowrider Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
k i got a couple questions.. i have a 2 pump 4 dump setup on my ranger heres the problem. when i lock the rear up the front lifts even.. if i dump the rear a bit the drivers front drops quicker .. ive changed the check valves, ive changed the dump seals. and ive swapped accumulators from one to the other so im not sure what the problem is here.. could it be that the rear lines arent the same length?im at a loss here as to why its doing it.. i really wanna get this solved so i can be cruising and be able to adjust the front evenly...


also what should my accumulators be charged at for use in a minitruck? i have the regulator and nitrogen bottle at work all i need is the fitting and i can fill them myself. its a 86 ranger std cab long box with a 302 in it....

whats the correct procedure for recharging the accumulators so i dont hurt them? is it the same a a nitrogen cylinder?


thanks in advance!
 

· Registered
Joined
·
54 Posts
Discussion Starter · #5 ·
no.. i have a pump for the front and a pump for the rear... as long as the rears are locked up the front lifts and dumps even.. but if i drop the rear a little then the drivers side front lifts slower and dumps quicker. im not sure whats going on ...

i have switched accumulators from one cylinder (front and rear) to the other and it made no difference i thought maybe the pressures were different in them

is it possible that the uneven lines are causing this??? im at a loss.. i really gotta figure this out so i can ride a lil lower and still be level...



Trevor
 

· Registered
Joined
·
54 Posts
Discussion Starter · #7 ·
mine lays out fine........ it just will not ride even.. i want to be able to raise and lower evenly ..
hope someone knows whats goin on
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top