LayItLow.com Lowrider Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
Ok, 2 days ago everything was fine. Today I hit the switch and nothing happend. So I checked the ground, relocated it from the rack to the frame and still nothing. I can hot wire the pumps (run a wire from the pump to the positive on the battery) and it works that way. So I know it is not the ground. Trying to figure out if it is:

the switches themselves (running 2, one for front one for back)
Switch cord
or solenoids (Ive only seen them stick when the go out)

any suggestions, tips, comments?
 

· Registered
Joined
·
67 Posts
Discussion Starter · #6 ·
Originally posted by k gee+Aug 3 2005, 02:43 PM-->
i suggest getting it fixed
heres a tip, dont burn the car down
id like to comment on your post....it was done well with proper english, punctuation and spread out nicely...

good job :thumbsup:
[snapback]3535237[/snapback]​
[/b]
:roflmao:
umm thanks?
<!--QuoteBegin-NastyRedz

Its gotta be somethin dumb it usually is.
[snapback]3535237[/snapback]​
Sure was. The connector for the power wire to the switch's came loose at the battery.
Put a new connector on and its all fixed now.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top