Lowrider Forums banner
1 - 2 of 2 Posts

· Registered
100 Posts
Discussion Starter · #1 ·
I trust my welder, but when I look at the pictures of cups on the internet, they look like they were machined out of a solid piece of alluminum. Should I make some or not?

All I have left to finish my car is some powerballs (showballs...whatever), and some cups for the front and rear. My problem is money obviously. $170 would buy me what I need, but I just had to spend that exact amount on yanking a fucked off molar.

By the way, what cups do I need for what? Deep cups for the front and reverse deep cups for the back?

Any feedback would be awsome. Thanks.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.