manual lock up lever
Join the discussion
Recommended Reading
-
LINCOLN TOWNCAR THREAD.......
HydraulicsHow to fit 13's on the lincoln Everyone has there own way and opinion of doing this. I guess its safe to say, that either way you do it, 13s will fit on your car. A) Swapping out the 95-97 spindles with 90-94 spindles. And they will bolt right up (this is actually the right way to do this...- 4K
- 426K
-
SHOWTIME916 · updated
-
Aircraft Hydraulics, Pictures and Info!
HydraulicsLets start a new thread..no more bullshit! I apologize for all the Drama in the other thread...IGNORE THE NEGATIVE POSTS! I need the serious Aircraft Enthusiasts in this thread. THANKS IN ADVANCE! I will start out with FIREFLY"S set up since we fucked up his thread! here is some random...- 8K
- 586K
-
TOPFAN · updated
-
Cylinder shaft blew out
HydraulicsHey guys i recently changed my whole setup including my boot. I was out rolling on the weekend lifted the rear and blew my rear cyls apart. Both at the same time. Punched the cylinder shaft and piston straight out of the outer tube and past the lock nut. I have not heard of this happening...- 0
- 75
-
Need help on mounting pumps as close as possible
HydraulicsI want to get these in the spare tire well on my car , so i spun the blocks , can new holes be drilled and tapped on the bottom , is there any oil passages i have to worry about , and with the mounting holes already there can one block be drilled completely drilled threw and a bolt ran threw and...- 1
- 75
Join now to ask and comment!