LayItLow.com Lowrider Forums banner

1 - 12 of 12 Posts

·
Registered
Joined
·
1,190 Posts
Discussion Starter #1
Sup people I need help with my 86 Cutty. Today I locked it up and when I dumped it the damn cylinder came out of the cup on my right front. We disconnected the ball joint to see if we could fix it but no luck it didnt move. What do I have to do to get that damn cylinder back in the cup. Worst thing is I have to have it ready by tomorrow morning. :angry:
 

·
Registered
Joined
·
4,446 Posts
bolt it back on and this time use red loctight :cool:
 

·
over it
Joined
·
6,640 Posts
Originally posted by Psycho631@Nov 15 2008, 07:02 PM~12166655
bolt it back on and this time use red loctight :cool:
Also make sure to wash all the oil off the threads of the bolt and the cylinder with carb cleaner and dry them off first. Loctite doesn't work for shit if applied over oil.
 

·
Registered
Joined
·
1,190 Posts
Discussion Starter #5
ok will do
 

·
Registered
Joined
·
1,190 Posts
Discussion Starter #7
Originally posted by 41chev@Nov 15 2008, 08:46 PM~12168511
did it go back together?
No success. that cylinder seems to be stuck because it wont move.
 

·
Registered
Joined
·
720 Posts
Originally posted by ssf650guy@Nov 15 2008, 11:24 PM~12169178
No success. that cylinder seems to be stuck because it wont move.
can u post up some picts to see what you are dealin' with? if its extended u might have to tap the shaft into the casing with someone tappin the switch to open the dump so u dont have to disconnect the line to release the preasure
 

·
Registered
Joined
·
1,190 Posts
Discussion Starter #9
Originally posted by d.j.Lowlife@Nov 16 2008, 12:13 AM~12169828
can u post up some picts to see what you are dealin' with? if its extended u might have to tap the shaft into the casing with someone tappin the switch to open the dump so u dont have to disconnect the line to release the preasure
I will try that, makes sense. I will also post a picture later on.
 

·
Registered
Joined
·
9,793 Posts
if the cylinder jumped out of the cup then there is i chance the cylinder will be bent hence the reason it wont dump the only way to find out is to pull the front end appart and take the cylinder out
 

·
Registered
Joined
·
9,670 Posts
:0
 

·
El Joven Viejo
Joined
·
1,745 Posts
disconnect the hose then push it in hopefully ur cylinder aint bent bent
 
1 - 12 of 12 Posts
Top