LayItLow.com Lowrider Forums banner

1 - 20 of 71 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
ok when i put the 2ton coils they wher a full stack but cut them down to a three turn now the problem is my cylinder shoots up and bent the seat a lil but not bad but is it because i got 10 inch cylinder working the rear and if i put a 8inch cylinder would it be ok?
 

·
GOFUCKURSELF
Joined
·
16,534 Posts
u sure its a 10"
 

·
GOFUCKURSELF
Joined
·
16,534 Posts
Originally posted by #1baghater@Feb 7 2010, 09:05 PM~16543811
and when i lay it down the cylinders are ok but when i lock it up the cylinder shoots up
Its a hard top???
 

·
Registered
Joined
·
109 Posts
Discussion Starter #9
WHAT I GOT CIRCLED THE CYLINDER SHOOTS UP AND HITS THE METAL PIECE UP AND PUSHED MY SEAT OUT BUT WHAT ITHINK IS I NEED A SHORTER CYLINDER
 

·
GOFUCKURSELF
Joined
·
16,534 Posts
Use a 10" side port cylinder
 

·
SO FRESH!!!!!
Joined
·
12,453 Posts
put another turn of a coil in and your angle of your cylinders sunds like it off
 

·
Registered
Joined
·
109 Posts
Discussion Starter #19
Originally posted by MINT'Z@Feb 8 2010, 10:42 AM~16548734
put another turn of a coil in  and your angle  of your cylinders sunds like it off
is ther any picture how you could show me? but i want it to lay still
 
1 - 20 of 71 Posts
Top