LayItLow.com Lowrider Forums banner
1 - 7 of 7 Posts

·
over it
Joined
·
6,640 Posts
That lower control arm would benefit from the plate wraping around the lower ball joint. The way its welded will also cause a stress point at the edge of the weld. I have seen a few pics on here that showed lower arms breaking right about were the plate ends on yours. The uppers could be plated on the side as well to prevent bending them. Just trying to pass on some info not trying to dog your ride.
 

·
Registered
Joined
·
2,388 Posts
Originally posted by OUTHOPU@Aug 22 2006, 04:34 PM~6019816
That lower control arm would benefit from the plate wraping around the lower ball joint. The way its welded will also cause a stress point at the edge of the weld. I have seen a few pics on here that showed lower arms breaking right about were the plate ends on yours. The uppers could be plated on the side as well to prevent bending them. Just trying to pass on some info not trying to dog your ride.
ur ight dont weld up and down, unless ur conecting metals thats were it will brake
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top