LayItLow.com Lowrider Forums banner
1 - 15 of 15 Posts

·
Registered
Joined
·
15,630 Posts
Discussion Starter · #1 ·
whats the best, i mean BEST filler for screw holes they are factory holes im not filling dents or anything and im not afraid to sand a freind of mine said tigerhair? i want an experts opinion. thanks
 

·
Registered
Joined
·
15,630 Posts
Discussion Starter · #8 ·
metal, there are 25 screws that hold in these little pieces of trim on the roof of my wagon.
 

·
Registered
Joined
·
6,318 Posts
best way to do it IMO is to weld them up

You could kitty hair them

I wouldn't use bondo or finishing putty as it'll fall out eventually
 

·
Registered
Joined
·
6 Posts
if you can get behind the panel...just place a piece of copper or aluminum under/over the hole and weld it up solid. The welds wont stick to them. Just be careful when you weld/grind it down cause the heat will warp.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top