problem with hydraulics

379 Views 6 Replies 5 Participants Last post by slick_oo, Oct 3, 2006

slick_oo

Discussion Starter · Oct 2, 2006

my hydraulics keep dropping only the leftside?
what happened was i broke fitting in the right rear cylinder. Now i fixed that by changing the fitting.
So i lift the rear up and the left side starts dropping (never had this problem b4) it drops pretty quick with the right side still up

my set up is one pump in the rear with two dumps and one pump in the front with a "y" block

what is the problem?

Thanks
Ricky

Save

1 - 7 of 7 Posts

SIK_9D1

· #2 · Oct 2, 2006

Is there any oil puddles under your car? If not Close your slow down then raise your car up if it stays up then your dump is stuck open a bit if it still drops you have a bad Check Valve. Hope this help you out.
Tony

Save

slick_oo

Discussion Starter · #3 · Oct 2, 2006

thanks...anyone else?

any pics to show what the check valve looks like?

i have two checks?

if i have two dumps for the rear?

:uh:

Save

Pepper

· #4 · Oct 2, 2006

http://www.layitlow.com/forums/index.php?s...opic=277938&hl=

here are some pictures i took of my check valves. hope this helps

Save

enough_talkin

· #5 · Oct 2, 2006

you may or may not have two checkvalves....your slowdown is easy to find...its the only fitting that has a knob on it...tighten the slowdown with the car dropped and then lift it up

Save

ice64berg

· #6 · Oct 2, 2006

Originally posted by slick_oo@Oct 2 2006, 02:19 PM~6287413
thanks...anyone else?

any pics to show what the check valve looks like?

i have two checks?

if i have two dumps for the rear?

:uh:

its either one before the tee or two after the tee ...

Save

slick_oo

Discussion Starter · #7 · Oct 3, 2006

for the check valve is there a certain one i have to get?

i'm using showtime setup

Save

1 - 7 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month