LayItLow.com Lowrider Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
86 Posts
batts are low, or bad checks
 

·
Registered
Joined
·
4,908 Posts
Originally posted by hydros2004@Dec 12 2003, 04:20 PM
batts are low, or bad checks
You can pretty much rule out checks. Even if they were backwards then you could here it in the motors. More than likely it is electrical. Check all grounds and make sure all your batts. are charged.
 

·
Registered
Joined
·
6,749 Posts
also make sure your wires inside your wire terminals have not fried!! I have had this happen to me before. You will get the clicks, but no juice through the power wires ;)
 

·
Registered
Joined
·
8,700 Posts
Originally posted by 4pumpedCL@Dec 14 2003, 02:57 PM
sounds like a solenoid...one's clicking...passing on the power, but the one after that fails and no power gets to the pump. I've had solenoids go out for a few different reasons. Bad ground, low batteries, cheap solenoids, etc.
:thumbsup: :thumbsup: :thumbsup: I agree.
 
1 - 9 of 9 Posts
Top