LayItLow.com Lowrider Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
1,289 Posts
Discussion Starter #1
O.k, so I have a couple of pics and measurements of my Superpump USA pumpheads. The #8 pumphead measures up to exactly 55mm from block mating surface to backside and the mystery pumphead measures exactly 50mm measuring from the same points.

Does anyone out there in Hydroland have a couple of these beasts laying around that they could measure up?

Also, I noted that the block I took the mystery pumphead off of did not have any marking at all in relation to the pumphead number, as where the #8 pumphead's block is clearly marked...

In my comparison pic the #8 is on the top. The other pic is just to show what the pics just to show what the backside looks like...

Thanks for the help all....







Last edited by vwlownslo at Jan 8 2004, 09:11 PM
 

·
Registered
Joined
·
1,068 Posts
Fenner heads have that "S" on'em, might be a fenner, it looks like one :dunno:
 

·
Registered
Joined
·
2,671 Posts
Top looks like an eight. If so: Bottom is a six.
 

·
Registered
Joined
·
1,289 Posts
Discussion Starter #5
Fenners huh.... interesting!


it is hard to see in the second pic, but it says SUPER PUMP USA right on the back...

Is that typical of a Fenner pumphead?

CHEERS!
 

·
Registered
Joined
·
1,068 Posts
Originally posted by vwlownslo@Jan 8 2004, 07:59 PM
Fenners huh.... interesting!


it is hard to see in the second pic, but it says SUPER PUMP USA right on the back...

Is that typical of a Fenner pumphead?

CHEERS!
The fenners i have, have the s on'em like yours and look just like that pumphead. I don't really remeber but i'm pretty sure fenners have "fenner" stamped on'em. its probablty just a fenner copy.
 

·
Registered
Joined
·
970 Posts
my guess would be a #6 but then again identifiing pump heads is not my thing...
 

·
True-S Mike
Joined
·
251 Posts
the fenners witht he "superman s" is from reds isnt it? it dowsnt meen its a six. i had #8's years ago, and the reds super heads all had the s's on em. mine were in the lowrider2000 series back in 98-99?
 

·
SINGLE PUMP NO WEIGHT
Joined
·
19,175 Posts
skinny center = #6
 

·
Registered
Joined
·
3,709 Posts
the "S" one is a reds gear, probably from when they stopped using fenner? looks like a 5 or 6?

all of the real fenner gears that i have seen had a part # like "pn106" or "pn108". and i thought the "pn33" was the Lowrider Hydraulics #10 head, maybe made by fenner?
not all of the fenner gears has the "stone" s on them, some just had the part number.

i hope i remember all of that right, it has been a while.
 
1 - 11 of 11 Posts
Top