LayItLow.com Lowrider Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8,058 Posts
Discussion Starter #1
I dropped the Driveshaft and took the old seal (rear seal where the driveshaft goes into the tranny) out, my only problem is the new seal is a bitch to get up in there, is there something I can use to make the job less irritating or go alot smoother ?
 

·
Registered
Joined
·
2,010 Posts
Yes, put grease around the outside of the seal (metal part) and then use a rubber mallet to hammer it in, stirke the metal portion with the hammer evenly, not just on one side, it will go in easier this way, WEY. :biggrin:
 

·
Registered
Joined
·
8,058 Posts
Discussion Starter #3
I have tried that but not grease used some tranny oil but still nothing I just gave up cause it was getting frustrating but after this beer I will give it another shot, Thanks Calilow
 

·
Registered
Joined
·
6,115 Posts
If that don't work try a six pack. :biggrin:
 
1 - 4 of 4 Posts
Top