LayItLow.com Lowrider Forums banner
1 - 17 of 17 Posts

·
Registered
Joined
·
24,862 Posts
Discussion Starter · #1 ·
any of you guys running stock perches with mucho batts???

just wondering/exploring my options with a little project..

thanks..

eazy :cool:
 

·
Registered
Joined
·
563 Posts
cut off completely weld powerball to channel -weld c channel to rear end -top and bottom than your reinforcement
 

·
Registered
Joined
·
24,862 Posts
Discussion Starter · #4 ·
Originally posted by ROCKSOLID84@Sep 9 2006, 09:53 AM~6136298
cut off completely weld powerball to channel -weld c channel to rear end -top and bottom than your reinforcement
upper perches..
 

·
Registered
Joined
·
9,793 Posts
i still run the std perches i just joined them with a channel and so far its been fine with 10batts n 4 pumps :)
 

·
Registered
Joined
·
2,930 Posts
i ran the channel top over the stock perches and welded it all together along the rail and into the chassis reinforcement, works fine
 

·
Registered
Joined
·
10,737 Posts
i would cut those things off and put whatever kind of bridge you want to use in there.....channel isnt the greatest looking thing so if you want to get fancy im sure you could come up with something that will hold up to the stress


those perches are fucking trash though
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top