LayItLow.com Lowrider Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I put new seals in my cylinders every other month. Any body know what to do? I am tired of them leaking all the time and the guy that did the work is unreliable. Most of my product came from Orlies here in Phoenix (please dont bag on me I get it enough). The car is not ever hopped or a daily driver, it only goes out cruising once in a while.
 

·
Registered
Joined
·
6,613 Posts
Originally posted by badass 64@Aug 19 2005, 02:11 PM~3656982
You need to hone 'em. No matter how good seals you run if they're not honed properly.
hone the inside of the casings when you change the seals. Ift they go bad again in a short time. Buy higher Quality cylinders and take a close look at how the cylinders are installed. Good cylinders dont go bad for no reason.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top