solenoids

365 Views 4 Replies 4 Participants Last post by goinlow, Oct 11, 2006

necr

Discussion Starter · Oct 9, 2006

hi,

i'm a newbie, so please some help.

where do i have to connect the 2 connectors on the top of the solenoids?
the diagrams on the site can't help me, cause on all the diagrams they show there's no connection to the solenoids, so please help me..

i have a red's 2 pump kit with 4 solenoids, 4 batteries and 4 dumps.

thanks so much

Save

1 - 5 of 5 Posts

soloco

· #2 · Oct 9, 2006

THE S ON THE SOLENOIDS GOES TO YOUR SWITCHS TO LIFT.DON'T USE THE I.

Save

necr

Discussion Starter · #3 · Oct 11, 2006

ok, but how can the solenoid work if there's only 1 wire connected? i don't understand.

please help, thx

Save

look_what_i_can_do

· #4 · Oct 11, 2006

run the wire from the up side of the switch to the S of the first noid then a wire from that S to the S of the next Noid.. that way they clicik together...

Save

goinlow

· #5 · Oct 11, 2006

S is for switch
I is for idiot

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month