LayItLow.com Lowrider Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
261 Posts
Discussion Starter #1
My old install was..
Rockford fosgate..Symmetry epx/2..
Rockford fosgate..Power 500/2..runing pair10" power dvc'[email protected] 4 ohm...
Rockford fosgate..Power 500/2..runing Rockford "Fanatic" 6" components up front...( 4 ohm )..

Bass was good.. but could be better..
front end..sucked...

i have a lot of cash tied up in this equipment so i wish to re-use it all but not the components...

i also wish to compeat and show with new install..
what i was looking to do, was use rocky amps to 1 sub each @ 2 ohm..
buy a new amp and components for front end..

i do not want to run any rocky equipment up front ( toooo harsh a sound )..

so then what amp/components will give me tight soung quality, with losing points on the system because not all amps will be from same manufactorer..


any ideas guys..??
 

·
Registered
Joined
·
261 Posts
Discussion Starter #3
Originally posted by ohsolow@Nov 13 2003, 11:36 PM
mb quart for ur componets and ppi amp
i do agree
Mb Quartz=Tight
PPi= Very tight

if i went to compete ( SQ+) with so many different makes in one vehicle.....would i lose points..
 
1 - 3 of 3 Posts
Top