Telescopic Cylinders

1403 Views 22 Replies 11 Participants Last post by WEST COAST HOPPER, Aug 17, 2005

YellowAmigo

Discussion Starter · Aug 14, 2005

Just a taste of the 30" telescopic rear cylinders that we are making....
My Machinest is garenting them not to bend!!!!

Give me some input and he will be on here to answer any size questions.....

See less See more

Save

1 - 2 of 23 Posts

juandik

· #5 · Aug 14, 2005

Originally posted by CrazyCutlas@Aug 13 2005, 10:53 PM~3613370
hey man the end cap is welded in no threads there are 7/16 45deg angle bevels for weld on both there is no way that any pump made by any one could make enough pressure to break that appart....there is a 16th slipped down inside thre for localtion as well that help strength..........is that 3 inch the out side diameter of the bigger tube or the piston size...........

I THINK V MAX TOLD US IT WAS 3 INCH OD ON THE TUBE. AND WITH THAT MUCH WELD THEY SHOULDN'T LEAK.

Save

juandik

· #15 · Aug 16, 2005

Originally posted by BlackMagicHydraulics@Aug 15 2005, 09:49 PM~3630420
Are you talkin about ''PINKY"" from Pinky's tire and wheel out of El Monte'.........

Because i made his.....500.00 for the pair 3'' I.D 35'' fully extended and those things use alot of oil...............

no sir .....i was talkin about the monte from ohio .

but where has that car been at haven't seen it in the videos lately

Save

1 - 2 of 23 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month