[impala1966]

Hi guys,

I finally got my new 350 sbc to work. I took out a 283 sbc and replaced it w/ a 350sbc. I left the transmission which was working before the engine was replaced (powerglide trans)

after installing the new engine, i checked the linkage from teh steering columm to the transmission and it was hooked up correctly ..HOWEVER, when i shift P-R-N-D-L nothing happens

it's like the car is in NEUTRAL.

all i did to the transmission was replaced the pan w/a chromed pan

any ideas why this is happening??

please help me

 

[impala1966]

I was told my torq cov needs to be hook up correctly w/ the transmission pump..it needs to snap in there somhow..so i have to unbolt the torq conv from teh flywheel and move it so it snaps to the tranny.. fuk this sucks

 

[Foompla]

what part of jersey u from?

 

[impala1966]

central jersey

somerville

 

[impala1966]

if you have any technical problems besides hydraulics..this website is WAY BETTER

http://hotrodders.com

you will get a response fast..not like here

 

[dcracing28]

With a Power Glide 2 speed you have to put the torkconverter on the shaft of the tranny and if you look there are 2 notches on each side of the converter. You have to line them up and slide them together then turn the converter, I forget which way, to lock the converter in place. Then put the tranny in place, making sure that the tits line up and the shaft goes in straight and bolt her up. Good luck :thumbsup: