LayItLow.com Lowrider Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
808 Posts
Discussion Starter #1
ok so i got a basic 2 pump coil under setup and i wanna 3 wheel my 63 (no reinforcement at the moment).

this is my list of what i need to so far to ensure my tre is on the road all the time.

1. Power Balls and gear to go coil over in the back

2. Slip yoke driveshaft and the stronger centre bearing

3. 12 inch cylinders

4. individual dumps for the back cylinders

so what else do i need? and what reinforcing should i do to make sure nothing buckles?
 

·
Registered
Joined
·
13,549 Posts
Originally posted by B_BORGERDING@Oct 27 2007, 09:03 PM~9097650
Don't 3-wheel until you reinforce!


bullshit if it's a hard top that car will 3 wheel all day

don't help much to do the arch's on a x frame
unless you are doing the whole frame and most people don't want to
 

·
Registered
Joined
·
14,802 Posts
man an impala x frame comes right off the car easily. i believe its 10 body bushings. remove the front and back bumpers, unplug anything thats connected to the firewall and motor. and let the frame out from under the car motor and all.
 

·
Registered
Joined
·
808 Posts
Discussion Starter #5
its a 4-dr hardtop. and you are right i don't really wanna reinforce the whole frame just to be able to 3-wheel. seems like a lot of effort.
 

·
Registered
Joined
·
808 Posts
Discussion Starter #6
plus living in australia its not like i can even pay someone to do it properly, the only guy doing that lives in melbourne, about 18 or so hours drive away
 
1 - 6 of 6 Posts
Top