Lowrider Forums banner
1 - 1 of 1 Posts

· Registered
169 Posts

just point it out with a needle first and then...take the 0,75 mm diameter bit and place into your dremel en gently use your hands and go drilling...

and remember... never turn your dremel on...just unhook it from electricity first..okay....

cause the speed of the dremel itself will fuck up your hole...

good luck dude..

Peaz and Beans
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.