Lowrider Forums banner

whats better

585 Views 5 Replies 5 Participants Last post by  jevries
are t sliders better than u-bars for hopping,possing ?


ohh yeah p.s can u do 3 wheel with t-sliders(i don think so :dunno: )

Last edited by h-town's playa at Aug 4 2003, 05:43 PM
1 - 1 of 6 Posts
Originally posted by joebomber52+Aug 4 2003, 06:08 PM--></span><table border='0' align='center' width='95%' cellpadding='3' cellspacing='1'><tr><td>QUOTE (joebomber52 @ Aug 4 2003, 06:08 PM)</td></tr><tr><td id='QUOTE'><!--QuoteBegin--1ofaknd@Aug 4 2003, 05:38 PM
man you got a lot to learn. j/k wit cha ;)

u-bars for hoppin' although with the right setup you can do three wheel and side to side.

t-sliders for dancing. two motors to each=4motors-1per corner.

i use u-bars almost always cuz it's easier to fab together, although i have 1 hoppin hydro chassis with t-sliders, and it was fun while it lasted :thumbsup:
i have hade a diecast 1/24 hopper with t-sliders for 4 years the thing my opinion is way better than the u bars i dance it and hop it till it flips over it's been running good for 4 years[/b][/quote]
I have had no problems whatsoever with U-bars it performs great and besides that it looks a lot better than T-sliders.
A good combo would be T-slider in the back U-bar up front.
It's all about adding a bit of weight in the back and with a diecast there should be no problem whatsoever. ;)
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.