[da_six4]

im wiring planning on putting in my set upo dont really got the flow to pay some one and everyone i know that knows how to do it is full of shit so i have a basic idea of wat to do i got two pumps 4 dumps 10 switches the dumps have two red wires each ......one goes to the noid and wer does the other go i got a diagram from the switch box on were the wires go as far as color to fron back left right ect but does any one have a pic of a diagram to wer everything goes thanks in advance for your help

 

[team we be strokin]

Tech section bro... one to the switch wire one to ground

 

[da_six4]

does it matter wich they both red

 

[maico805]

This will be your best friend while you learn to wire it all up

http://www.layitlow.com/tech.shtml#switches

And either can be ground

 

[da_six4]

my switches are already wired just having troubl as far as the noids to switchbox and noids to pumps

 

[da_six4]

ttt

 

[TYTE9D]

Should be one wire from front switch to noids and one wire from rear switch to noids. Then off each bank of noids one cable to each motor. Ground one dump wire to itself or the block etc... Other dump wires go to switches. Dont forget one wire from switch panel/box goes to 24v for power. Hope that kinda helps.

 

[da_six4]

preciat it i think i got it now