[brizzyb]

I am in need of an explanation to how I wire the eight wires from my switch box to my two spool valves. I figured, group them together : front up, front down/rear up, rear down (two for each) but then, which prog do I connect those to on the valves, to do front and back?????????????Helpppppppppppppppp!!!!!!
I appreciate any help!!!!!!!

 

[Tuna_Sammich]

cand do it, you need to gut all the wires and rewire the switches..

you'll need 5 wires total



Last edited by 216RIDER at Oct 21 2003, 02:41 AM

 

[brizzyb]

what do you mean I cant do it, I can do anything if i figure out how.
Can't I just leave some of the wires out?????

 

[Tuna_Sammich]

I would think some wacky stuff would occur, but try it out and let us know what you find out!

 

[Bumps N Jumps]

He can still do it. All you gotta do is just group together some of the wires instead of having to re wire the whole box.

 

[Tuna_Sammich]

I would assume that the side to side functions would be all screwy..

left/right up/down would become pancake up/down

front left or front right up/down would become front up

back left or right up/down would become back up/down

front to back seesaw would be fine, as would pancake, front, and back

 

[Swingin80Lincoln]

whats the point of a 10 switch box with only front and back? just want the look of a 10 switch box or what?

 

[brizzyb]

Well I grouped the front left and right up together, the front down left and right together, then same for the back and I can currently use (with control), three(technically four) switches. It wasn't as hard as I thought. And the reason I went ahead and wired the ten switch box is because I am getting two more spool valves to do f,b,ss, and dogleg. Thanks for all your help. i'll holla!!!!!!!
BRIZZY-B