[ILUVMY82]

im gonna use diamont bc/cc but i was wondering if i had to use their primer or if i could use some other primer also the primer i have in mind is
U-POL primer i wonder if its compatible.
Also i sanded down my car and then all of a sudden it rained i got a car cover for it and it was under the drive way just wondering wat i should do to prevent rust from the moisture in the air

 

[hotstuff5964]

you need to epoxy primer that shit immediately if its in bare metal, especially if its gonna be outside.

 

[mashingbumper]

Yea that's very true epoxy needs to be on there for good protection but before you spray that make sure you etch if you had it in bare metal otherwise rist in already eating away at your ride

 

[fleetwoodpimpin]

you dont need etch primer if you use DTM epoxy

 

[ILUVMY82]

THE WHOLE CAR ISNT METAL JUST IN SOME HIGH AND LOW SPOTS AND A COUPLE AREAS ABOUT A HALF A SQ FOOT and im not done with some of the body work yet you think i shoud just sand the metal parts again before i prime or shoot epoxy

 

[redline]

Originally posted by fleetwoodpimpin@Dec 15 2008, 01:22 PM~12434102
you dont need etch primer if you use DTM epoxy

x2

 

[FatBoYz85]

ttt

 

[ILUVMY82]

TTT