Wraping a 64 Imp.

719 Views 3 Replies 4 Participants Last post by badass 64, Oct 30, 2003

nick

Discussion Starter · Oct 30, 2003

I am an Australian, new to this forum and new to lowriding. I need to know what gauge steel to use and how far along the chassis? Would 1/4 inch from the front spring housing to the rear be enough? Any ideas?

Save

1 - 1 of 4 Posts

78 Monte Rider

· #3 · Oct 30, 2003

Wrap it with 3/16 and you won't have to worry about it again if you have a good welder. peace out

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Tech
Hydraulics
Wraping a 64 Imp.

Top Contributors this Month