Howsit People,
I'm in New Zealand and looks like i got a 4 door impala coming my way (2 doors very hard to get here), been researching the juice and have a few questions. Am new to this so please take that into consideration when thinking my questions are sad.
(don't give me your opinions on the 4 door because I don't give a fuck what people think)
Setup is Black Magic 10" and 8" 2 pump 4 dump
2 coil overs, 2 coil unders.
Are the coilovers for the rear with the 10" rams?
Obviously coil unders are on the front with the 8"?
Do you need to re-inforce the complete frame or just certain points and if so where abouts?
I cant cut springs and get it on the road here in New Zealand so are there other springs you can use?
Shocks are also a legal requirement here any suggestions what to use with this setup?
What happens with the drive-shaft? Telescopic yoke or is this unnecessary with this setup?
What a - arms need to be extended? I've read about 1" should be sufficient.
I have built a few drift cars and am a ticketed welder with my own gear, only a complete rookie in the lowrider scene but have good engineering knowledge. Any help is much appreciated, thanks very much.
I'm in New Zealand and looks like i got a 4 door impala coming my way (2 doors very hard to get here), been researching the juice and have a few questions. Am new to this so please take that into consideration when thinking my questions are sad.
(don't give me your opinions on the 4 door because I don't give a fuck what people think)
Setup is Black Magic 10" and 8" 2 pump 4 dump
2 coil overs, 2 coil unders.
Are the coilovers for the rear with the 10" rams?
Obviously coil unders are on the front with the 8"?
Do you need to re-inforce the complete frame or just certain points and if so where abouts?
I cant cut springs and get it on the road here in New Zealand so are there other springs you can use?
Shocks are also a legal requirement here any suggestions what to use with this setup?
What happens with the drive-shaft? Telescopic yoke or is this unnecessary with this setup?
What a - arms need to be extended? I've read about 1" should be sufficient.
I have built a few drift cars and am a ticketed welder with my own gear, only a complete rookie in the lowrider scene but have good engineering knowledge. Any help is much appreciated, thanks very much.
